Fine-tune how it works: favourite positions, direction, switch type and calibration.
Window settings
Settings overview
Open the settings with the gear in the top right of the window detail screen. They are divided into three groups, the same as below: Favourites, Window and Controller. After each change the app confirms that the device has been updated successfully; tap OK. Tap a setting below for a description.
- 1Tap the gear for settings
- 2Open/closed sensor (PRO)
- 3Close the message
Settings
Favourites
Two saved positions you can move the window to with one tap, using the Favourite and Ventilation buttons on the window detail screen (see the Use tab). They are stored on the phone, so each phone has its own positions, and you set them again when you change phones.
Favourite
Move the window to the desired position with your finger or use Open or Close. Tap Save and confirm with OK. The position is saved on the phone.
- 1Save the position
- 2Fully closed
- 3Fully open
- 4Set the position with your finger
- 5Confirm
Ventilation
Works the same as Favourite: set a position for airing, for example a partly open window, tap Save and confirm with OK. This position is also saved on the phone.
- 1Save the position
- 2Fully closed
- 3Fully open
- 4Set the position with your finger
- 5Confirm
Settings
Window
Settings for the window and the actuator. They apply to the device, so all users see the change.
Rename
Enter a new name and tap Confirm. The Confirm button becomes active once you change the name. Keep the name short: room first, then position, for example “Bathroom roof window”.
- 1Enter a new name
- 2Confirm the name
Recalibrate
Runs the calibration again, for example after replacing the actuator or changing the stroke. Confirm with Yes. During calibration the window moves by itself, so there must be no people, animals or objects in the window opening or in the path of the sash.
- 1Confirm calibration
- 2Confirm
Reverse direction
Select what is reversed. If the window moves the wrong way from both the app and the wall switch, select Motor. If the app works correctly but the switch works the opposite way, select Switch. If it moves the wrong way from the app but correctly from the switch, select Both. No rewiring is needed.
- 1Motor direction reversed
- 2Switch direction reversed
- 3Both directions reversed
- 4Confirm
Switch type
Select what is connected on the wall: a switch stays in the pressed position, a push-button springs back after pressing. With a push-button, if you press the same direction twice in a row, the window keeps moving in that direction until you stop it or it reaches the end position.
- 1A switch is connected
- 2A push-button is connected
- 3Confirm
History
Shows who moved the window and when, and to which position.
Settings
Controller
Restarting and removing the device.
Restart device
Restarts the controller, for example if the device does not respond. The settings remain saved. You can restart it yourself. Confirm with Yes.
- Confirm the restart
Delete device
Removes the device from the app. Confirm with Yes. Also delete the device if the controller has been reset to factory settings, then add it again.
- Confirm deletion
Next
What's next?

And peace of mind when you are away.A smart window controller with opening detection and notifications, designed and made in Slovenia.
Need help?
You're backed by our team in Kranj, who developed the system and make it. In your message, include the controller model and briefly describe the problem. You'll get a reply within 3 working days at most.
First check the tab Troubleshooting.
Write to us Book installationinfo@adcsmartsystems.com