ADC sistemi
RemotesUpdated November 2, 2026

ADC
Smart Shade Remote

Ten-channel remote for ADC shades. It controls the shades directly over Bluetooth, so it works without internet too.

  • 10channels
  • 5shades per channel
  • 2× AAAbatteries
  • Bluetoothno internet needed
The gold markers on the screenshots show where to tap. Click a screenshot to enlarge it and see what every button does.

Support

Troubleshooting

A shade does not respond to the remote

Check that the right channel is on the display (left and right buttons). The remote talks directly to the controller over Bluetooth, so stay within range. Also check that the controller has power. The display switching off 30 seconds after the last button press is normal. If it does not light up when you press a button, replace the batteries.

The display switches itself off

This is normal. The remote switches off 30 seconds after the last button press to save the batteries. It switches on again when you press a button.

My phone cannot find the “ADCRemote_…” network

Check that the batteries are inserted correctly and that you are close to the remote. The remote is ready for setup when the display shows “C”. If it already has channels set up, you can reset it to factory settings (see below).

A channel does not appear on the remote

The remote only shows channels that have at least one shade. Add a shade to the channel in the ADC Home app.

The up and down buttons move the slats instead of the blind

The remote is in slat tilt mode: there is a dot next to the channel number. Hold the stop button for 2 seconds or press left or right to return to normal control.

I cannot add another shade to a channel

You can add up to 5 shades to one channel. Use another channel for additional shades.

Does the remote work without internet?

Yes. The remote controls the controllers directly over Bluetooth, so it also works when your home Wi-Fi or internet is down.

When should I replace the batteries?

Battery life depends on battery capacity and how often you use the remote. The remote does not warn you when the batteries are low. When the display no longer lights up when you press a button, or the remote does not respond reliably, replace both AAA batteries at the same time: slide the cover on the back down with your fingers.

Resetting to factory settings

Open the battery cover. The reset button is in the battery compartment, between the contacts on the top edge. Hold it for 3 seconds. The remote returns to factory settings and the display shows “C”. After the reset, add the remote to the ADC Home app again and assign your shades to channels.

  1. Hold the reset button for 3 seconds

Need help?

You're backed by our team in Kranj, who developed the system and make it. In your message, include the controller model and briefly describe the problem. You'll get a reply within 3 working days at most.

Write to us Book installationinfo@adcsmartsystems.com